Honda Talon (2019-2021) and Talon 1000R (2019-2022) | 1.5 Inch Wheel Spacers | 4x136
Honda Talon (2019-2021) and Talon 1000R (2019-2022) | 1.5 Inch Wheel Spacers | 4x136
by Rough Country
Couldn't load pickup availability
- Widen Your Track Width for improved trail performance
- Durable 6061-T6 aluminum construction
- Corrosion-resistant and ready to withstand the elements
- Lightning-fast installation with pre-installed studs
- Increased functionality and aggressive appearance for your Honda Talon and Talon 1000R
- Limited lifetime replacement warranty against manufacturer defects
- See below for more details and specs
About This Product
Give your UTV a wider track width and increased stability with Rough Country's Aluminum Wheel Spacers. These ultra-durable spacers are constructed from 6061 aluminum for a long lifespan of heavy-duty performance.
Widen Your Track Width: When taking to the trails and overcoming obstacles a wide track width is crucial. Rough Country's aluminum wheel spacers are a must for must-have accessory for your UTV.
Durable Design and Installation: Rough Country's 1.5-inch wheel spacers are constructed of 6061-T6 aluminum and are corrosion-resistant ready to withstand the elements. Each set of spacers offers pre-installed studs that make the installation process lighting fast.
Once installed not only will have a new aggressive appearance but the overall functionality of your Talon will increase!
Warranty: Rough Country's 1.5-inch wheel spacers have a limited lifetime replacement warranty towards manufacturer defects. As such, the product is protected from structural and workmanship damage after the date of purchase. With our industry-leading warranty, give yourself peace of mind when using Rough Country's products for your UTV.
Honda Talon (2019-2021) and Talon 1000R (2019-2022) | 1.5 Inch Wheel Spacers | 4x136 Details
Fits
2019, 2020, 2021, and 2022 Honda Talon and Talon 1000R
Installation Instructions & Videos
- Prepare the vehicle: Park the UTV on a flat surface and engage the parking brake for safety. Ensure the vehicle is turned off and the key is removed.
- Jack up the UTV: Use a jack or lift to raise the UTV off the ground. Make sure to place jack stands or blocks to support the vehicle securely.
- Remove the wheels: Loosen the lug nuts on the wheels using a lug wrench or impact wrench. Then, carefully remove the wheels from the UTV.
- Clean the hub surface: Use a wire brush or cleaning cloth to remove any dirt or debris from the hub surface where the spacer will be installed. Ensure it is clean and smooth for proper installation.
- Install the spacers: Take the spacer and align it with the wheel studs on the hub. Carefully slide the spacer onto the studs, ensuring it fits snugly and evenly. Make sure the spacer is seated properly against the hub.
- Reinstall the wheels: Place the wheels back onto the spacer studs and hand-tighten the lug nuts. Ensure the wheels are centered and aligned properly.
- Torque the lug nuts: Use a torque wrench to tighten the lug nuts to the manufacturer's recommended torque specification. Tighten them in a crisscross pattern to ensure even tightening.
- Lower the UTV: Carefully lower the UTV using the jack or lift until the wheels touch the ground. Remove the jack stands or blocks and lower the vehicle completely.
- Final tightening: Use the torque wrench again to double-check the lug nut tightness and ensure they are properly tightened.
- Test and verify: Start the UTV and take it for a short test drive to ensure everything feels and functions correctly. Pay attention to any vibrations or abnormalities and address them if necessary.